Bernzomatic® Bronze Flux-Coated Brazing and Welding Rods - Four 12 inch Rods for Everyday Repairs of Steel, Cast Iron, and Copper Metals; Working Temp of 1,595° to 1,630° F

Worked as expected for me. Should work well for you too if you know about materials and surface prep and PPE.

Fairly priced

I used this product to put back together the peacock in my backyard. It broke at one of the legs. I was worried that it would not hold up the weight of the peacock and the big rock, but it worked great and it’s still holding up and just spray-painted a little over it. Great product and easy to use. Thank you!

I repaired my wheelbarrow! I needed MAP gas to do it. Regular propane was weak at getting a good melt.

Always need braising rods for project & this works fine.

Needed this to repair a leak on a Viking stove gas line.

I hope that they last because I like them a lot and may even buy another pair.

The only thing I can figure is there must be good runs of these rods and bad runs of these rods. I read some have been able to work these rods with a propane torch. I never got close to getting these rods to met with a mapp gas torch, even when holding a flame directly to the rod. So I used my oxy/acetylene torch. Preheated the base metal until it was glowing and the rod still would not melt. With the base metal glowing and the torch on the rod it finally melted but not into a fine puddle that would run into the gap. It just melted into a clump of molten metal that I could not get to run into the seam. I had zero luck getting these to work.

I USED THEM FOR THE INTRICATE FOLD'S,, AND CREASES OF MY EXPANSION-CHAMBER FOR MY SKI-DOO,, IT HAD RUSTED IN THE WORST SPOT'S,, BUT THANKFULLY THESE BRAZING ROD'S FLOWED NICELY INTO THE DEEP CREASES,, AND FOLD'S OF MY EXHAUST,, WITH MINIMAL CLEANING TO THE METAL,, BECAUSE OF THE HARD TO REACH PLACES.

I'm thinking more like 99% Brass is more likely. But They work very well and the flux makes for great adhesion.

hard to work with

Product as described

Good value.