Plastic Hose Barb Reducer Fitting

Due to a shipping issue with Amazon fulfillment, I didn't receive this right away. The company was very accommodating and helped me get the fitting in a timely manner. I appreciate that! It works perfectly for the application that I needed it to, saving me lots of time. It is set up to feed the automatic humidifier inside of my quail hatching setup. It is a solid, well built item that should hold up in the rigors I plan to put it through!

It does exactly what it says on the tin: steps down a 3/8” tube to a 1/4” tube. It’s easy to push both sides into the hose, and forms a good seal. Would buy again.

I was told by a mechanic that the plastic reducers are better than the brass ones.

I ordered the barbed Reducer 1/4" to 5/32". Received the right sizing, but the barb was only at the tip. I had to use a clamp to keep it from leaking. It was used on an RO water system where I had replaced the original diverter with one of my preference. The tubing on the RO system was 1/4" tubing with 5/32" ID. The diverter required a 1/4" ID. The clamp is mostly needed on the input line and not the discharge brine line due to water pressure feeding the line that leads to output of RO water. .Luckily, I already had the proper fitting clamps.

Used it for a project Worked perfectly - fit well and did not leak

These are clear not white

Works as needed

It's too small on the 3/8" and too big on the 1/4" side. It resembles the photos which seems to be better than the experience of some of the other 1-star reviews. Attached photo shows tubing connected which is the specified ID's: 3/8" and 1/4". On the 3/8" side it's so loose that water is leaking out past all 3 sets of barbs, and on the 1/4" side I had to hold the hose in boiling water and then work very hard to get it only partially onto the fitting.

Good quality and precise measurements mentioned in website

Tel que décrit , ces good

Works good, sizes correct. Could be a bit better of a deal for two plastic fittings, 15 dollars is a bit outrageous but I can't find them in Canada for cheaper so I guess it is what it is.

When I ordered this product, it stated 20 pieces but only one arrived. Paid 14 times more than I was expecting.

Ordered the 3/16"-1/8" step down Barb fitting; the 1/8" end fit perfectly, but the opposite end was sized for a 1/4" hose. Very disappointed.