Inside Storm Door Handle

PERFECT replacement for my year 2000 LARSON Full-view Storm door inside latch! I bought this because it "LOOKED RIGHT" compared to my old dead one. IT WAS PERFECT. If you have an OLD LARSON DOOR, and this LOOKS like your inside latch, it probably is! - LARSON Part number 2024133 (inside latch part). - KEEP your mounting screws! - Handle is separate from the base and , as received, and mounts very nicely! - ALSO, I didn't need to use the 5/16" square spindle as it was nearly permanently still installed on my outside handle, but it comes off with a set screw just like the original one on my door. - I may never use the thumb lock, as my door has locking deadbolt, but it is not intrusive.

Handle came a week earlier than expected. No instructions on how to install but I figured it out. Installation was easy peasy even for this octogenarian. Took longer to remove that old handle than to install the new one. Looks great. Works super. So happy with this product.

Nice quality

Had to purchase a spindle kit. The spindle from my original handle was too long. I wish they would have included a compatible spindle.

Replaced broken handle with this one and it went on perfectly. Door now stays shut and opens easily with the new handle.

Great product compared to the factory latch on my 20+ year old Larson door. The latch got here in less than a week, I believe 5 days. my old latch had a 3/16" rotator bar, the new unit requires a 5/16" bar. Here is what I did. Get a chunk of 5/16" bar cut a 1" piece, carefully cross score the center of one end and center punch it, very carefully drill your 1" piece totally through with a small bit. Then enlarge the hole to 7/32" clean it up good with brake cleaner etc. mix up a small batch of JB Kwik, pack the hole full shove the 3/16 bar all the way in while trying to cover the other end thus forcing the cement around and out the other end Line up the splines, clean up the mess Trim the 3/16" end for length after it dries. You really need a drill press, a drill vise and a hack saw but I bet if you are a handy guy you can do it with a vice and a hand drill. G et a piece of 3/16"See if you can make the 1" piece berfor you order. Good luck, my door is works better than when it was new...GREAT PRODUCT!

The original larson handle corroded inside and we found ourselves without a handle. I took a chance on this handle and it works perfect. I actually like the locking mechanism better than the original! It's exactly what I needed. Keep your original spindle and screws for a seamless replacement.

was looking to buy just a replacement handle, but this complete set was less expensive and woks perfect.