Industrial Grade Cyanoacrylate Adhesive - Medium Viscosity, 8 oz, Super Glue

Lots of glue! I’m not a glue expert, but this seems like an impressive value. It is thinner than I expected. Similar to water. Probably not the best for kids. If you spill it you can do so quickly and it might even be a bit dangerous. Definitely could blind you if you splash it in your eyes. Being careless I managed to glue my pants to my knee when I spilled a good bit on my leg and it soaked through my pants and adhered to my skin. Good stuff! Just put it where you want it. I bought it to glue a boot sole back on my wife’s expensive hiking boots that don’t get worn much. Seemed to work well. Time will tell. I’ll probably also use it for some woodworking good repairs.

Like the bottle size, so much better for multiple projects than the tiny store bought bottles. Works great, holds great. Asked me to rate easy to remove? Gave 5 stars for that because it isn't, which is a good thing when it comes to permanent adhesion, but didn't want to rate it low when you shouldn't want what you are gluing to stay. Great product, becoming my go to. Only thing I would like different would be to have an extra bottle tip/end included, as over time if the end isn't cleaned, you'll glue on the lid which can become an issue. But really a great glue and price.

PSA: IF YOU SIT THIS BOTTLE OF GLUE DOWN KINDA HARD, the glue that is in the stem can be ejected. Only about a drop. But a drop of superglue in your eye is 3 drops too much. Wear glasses or be conscious of this and look away when you sit it down. Also, a small spray of mist or a dash of baking soda will make it set immediately. Baking soda can be used to make a polymer that can fill small holes and gaps and can be drilled and has as much or more integrity as the most plastic.. The medium viscosity is thin at room temperature and medium at fridge temp. It takes about twice as long to set when pulled from the fridge unless one of the mentioned accellerators are used. There are other accelerators I'm sure. This amoubt of superglue is a game changer for sure. Great product.

Glue worked well for a variety of tasks. The lid would glue shut but could be broken loose with pliers when needed. Biggest complaint. With about 6oz remaining the container showed evidence of melting or dissolving at the bottom after about 18 months. It also leaked and the fumes and leaked glue damaged surrounding items on the shelf and damaged the shelf. It was always stored upright with dry craft supplies and never came into contact with any heat or other chemical. Surprised me and was very wasteful. Will go with 2oz next time just in case

I use this stuff along with an accelerator for my finish carpentry. Whenever I have to install picture frame moulding on a wall I prefab the pieces so that the install goes smoothly. I bought the 8oz medium viscous bottle a few years ago. I store it in the basement in a cabinet and it keeps just fine. Recently, I had some moulding pieces left over and instead of throwing them away I cut them on a 45° angle and glued them together. You couldn't tell once it was sanded and painted. A little goes a long way. When I have two corners to glue together I put glue on one piece and the accelerator on the other piece, hold together for 20 seconds and then it's bonded. If it doesn't hold the first time, chances are the glue or accelerator was absorbed into the end grain of the wood pieces. Just try again. I always make sure to join pieces over a piece of plastic sheeting to protect anything from getting glue on it. Another great use when working is to use a few spots of CA glue along with wood glue. The CA glue holds the pieces together until the wood glue dries. I use this instead of clamps a lot. This stuff really changed the game! I cannot recommend it enough. Pro tip: if you have a Ped Egg (or knock off of one) use that to get dried glue off of your fingers. It hasn't failed me yet (follow all the warnings and instructions on the Ped Egg, of course). Update: I had to contact the vendor because the nozzle on my bottle was clogged and I was looking for a replacement. They didn't have one but replied on a Sunday evening and had recommendations for me to try. THAT'S customer service!

I've used this product for applying an acrylic CA finish on my acrylic & wood turned pens. The medium viscosity is perfect for this application. I typically purchase this 8oz at a time, however a little goes a long ways. This brand is also well priced for what you get. Purchasing in larger quantities nets you a better price. If you are going to store this long term, I'd suggest putting some in a small bottle and ensure it's air tight. I'm very happy with this product and will continue buying it so as long as I continue my craft.

Seller did not include a tip to dispense the glue. I’ve bought this three times. The glue is great. This is the first time that it didn’t come with a dispenser tip. Hard to use this product without the tip.

I primarily use this for paper, cardboard, and bass wood, currently. It’s very easy to use, viscosity is great, handling the bottle is great, tip is a nice size. Value is outstanding. Awesome product