Mr.Power Spring Reverb Tank 2EB2C1B for Replacement

Works perfetly and provides a good and adequate amount of spring reverb. Great price too.

Bought one in 2023 and never reviewed it! I buy, repair and resell old guitar amps as a side hustle and this works great as a replacement tank for small to medium size combo amps. Used the one I bought in a small Peavey from the 80s with excellent results.

Replaced a bad reverb tank in a Fender 112 plus amplifier. This was a direct placement and took about 5 minutes to complete. I was impressed with the sound and functionality of this reverb tank and I’m very happy I bought it. Brought the amp back to life and sounds great!

This worked great in a small "mostly leftover parts" build I did recently (tube amp, but solid state reverb driver). I was able to drive it quite well with an RC4580. The sound quality is fine. Proper mounting is a must + they are prone to pick up both near- and far-field noise (but this is the case with most reverb tanks), so filtering is prudent. I used it in a combo and found that there is a sweet-spot middle range in terms of how hard you want to drive them. Surprisingly, I encountered the most distortion when underdriven. This is not an artifact of tank distortion so much as it is the reverb-signal to ambient vibration (cone in the combo amp). But, following the usual wisdom (driving them close to their max) results in a reverb with a decay that sounds well in excess of 4 seconds (my understanding from the part number is that is should be closer to 2s). How hard you drive it impacts the perceived duration, so if you don't want a really long sounding reverb, cut the drive a little.

Less than 5 minutes, replaced the old non op unit and reverb is perfect. The fit was exact, reverb sound quality is just right. Very happy. Great value.

I used this to replace a broken reverb on Peavy Blazer. I followed a YouTube video to modify it properly to connect to the amp, and it works nicely. It's very good for the price. This may be an issue with the Peavy, but the reverb only seems to work between 6 and 10 on the dial. The sound is full and pleasant, with a traditional spring reverb sound, and the decay can go pretty long, with the mix creating some big atmospheric tones.

I bought this for a DIY music project I am working on. It sounds very good, but the actual springs and connections seem thin and cheap. I'm not sure how well it will hold up.

Cheap as chips and fixed my little Peavey...

It’s not the right size, but it works.

Worked great, I used it to repair an 1980s guitar amp

El producto buen acabado . El funcionamiento no es bueno y hace ruido el ampli

Funciona muy bien

La construction semble très sérieuse. L'installation sera à réaliser avec des vis à amortisseur. La bande passante est très étroite (environ 8Hz) avec le pic à 97Hz. Pour une tension d'entrée de 4,24V on obtient 144mV en sortie. Je verrai plus tard l'impression acoustique (vintage?)