JRready ST5262 2Pcs Molex Micro Fit Extractors Microfit Terminal Release Tool Kit for Molex MX3.0 Male/Female Terminals Microfit 3.0 Extraction Tool for Micro-Fit Terminals Pin Removal Tool Kit

If you work with circuit boards that use Micro Molex connectors and need to be able to de-pin connectors these are the best. High quality, precision fit, and with the ejector pin these are the best for the job. They make pin removal as easy as possible. If used correctly and once you get the hang of it you can de-pin a 12 pin connector in probably a minute or two without a problem. Highly recommend.

Bought for working around the house & automotive repairs. I have not needed to use it yet but appears to be well made and a good value for your money.

Works Great

Oh my gosh, this makes removing pins so much easier. People should recommend these when they tell you to get a crimp kit.

Excellent product. Would recommend. A must when working with Molex connectors. They work well for the intended connector types.

Little difficult to use, takes a while to figure it out

I found out about this product via a recommendation and is worth every penny. I have the original MicroFit Molex pin extractor and it bends every time I was using it making hard to extract the pins. When I started using the JRready it became so easy to extract the pins that jobs that will take me 10 minutes now takes me less than 2 minutes. Is a most have tool for anyone that work with MicroFit Molex adapters.

Returned, I ordered the incorrect ones

Microfit 3.0 connectors HATE you and refuse to be de-pinned, this is the only tool that i have found that allows you to remove them and they can be put in another pin socket afterwards. seriously they are expensive for a reason, they do the job, will still take you 3 goes to understand what you need to do but once you get the feel for them. my god, i have needed these not bought them cos they were expensive and now i have them i have regretted every time i chose not to by them.

so i got a set of these and so far so good took a bit of getting use to to use and first i used the male one in a female molex terminal and a female in the male one but once i got on to using then they ejected the terminal pins good but they do look very fragile so be careful not to jam them in or bend them once thier in the pcie connector cuz u will break them but i will def recommend them

What can I say more than has been already said: inexpensive and they work like a charm. If you work a lot with Molex MFT3.0 connectors, you want those. Buy them!

Ensure that you get the right ones for the right pins. These do more, but I bought them for the Molex™️ 3.0 series pins. They saved me a LOT of grief when building new cables and getting the pinout wrong at first. I was a klutz at first, so I need replacement tips for the female tool. Oh speaking of which, figure out which is for female and which for male and use appropriately, hint hint.

I bought this after spending hours making and using my own contraption to depin Molex 3s. This took several seconds. Even if I don't use it again it was well worth its price.