Prestacycle Presta Head

I have this on my compressor (the head has Schrader threaded fitting, which screws into an air gun nozzle), which I use to seat tubeless tires and it works with zero issues. It's actually brilliant: no levers or threads to screw onto, grabs onto the valve stem as advertised, simple push/pull operation. It seals just fine over 70 psi I use to seat road tires.Initially I was also using it with my regular tire inflator, but replaced it there with the same design but better look and finish head from the pretentious bike accessory company I should not mention here. It worked just as well but was a little bit too big. My inflator has constant airflow and a cut off pressure setting though, this design might not be that good for manual pumps with analog manometers.

This Presta valve adapter works very well. I was looking for a quick-install Presta valve adapter so I could use the Shrader Valve air compressor I have and this one is working great. Just push the adapter on and it's ready to use. It's very lightweight (since it's aluminum) so it's easy to carry with you if you need to. Great product.

Only used twice and worked well but the Interior soft grey material melted into goo while stored in my garage - it's hot in there during summer 95-100deg - but that shouldn't melt anything like this

So far it works great. The whole set up is a little bulky, having this unit attached to the universal head. Additionally, if attached to a pressure gauge will only show the tire pressure if air is added. But its worth the cost of not leaking and being easy to attach to the presta valve.

Finally a decent Presta head. I'm using this with my Bauer battery operated inflator from Harbour Freight.

Seals tight but nearly impossible to remove ... pulled harder, it released and jammed my hand into the sprocket. Bloody mess.

I pump my bicycle tires before every ride because I know how important it is to have proper tire pressure, not only for performance but also to avoid flats and tire failure. Back in the day, I used to use a Silca Track Pump that had a similar head, which was super easy to use, and worked very well. Prestacycle EZ-Grip Big Presta Head with the Urethane Elastomer gasket is just as easy to use, but it seals better, and I think the gasket will last longer. I have been using it for almost three months now and couldn't be happier. I have used many pump heads over the years, but I'll stick with this one from now on.

I use this to thread onto my cordless inflator. New style "rubber" inside gives good grip and seal.

Sper produit je m'en passerais plus!